Over the past week, I've also made the receiver after experimenting with different methods to make it. I tried using foam to make the exterior curve but that didn't work as well as I would have hoped. I then used card wrapped in fabric to give it the structure required to make the exterior walls using strong glue to bond it to the base which is birch wood (some wood scraps I had from a previous project).
I have some plastic with a good opacity that I will use for the top covering the technology after it is completely working. I've soldered all the currently working components together to make sure it will fit within the device, which it does.
Next with this part of the project, I plan to finish the technology and place the remaining side on. I'm hoping this component is going to be battery operated.
Коментарі